Print at 0.2 layers and no supports.

The problem is with this one it needs to sit on the ring side down. I need to rotate it 58.2 degrees.

Recomend ABS

For the camera to fit, you need to file the front standoffs. File the tubes in half, leaving about 5mm untouched on the top and bottom for the screws. Then cut the top plate CF back so there is enough fro the front stands only.

add thin heat-shrink to the verticals then to protect the runcam Swift sparrow.

Hot glue the camera in place, and screw the guard to the camera mounts. the back clips should clip to the supports.

This should give you good vision in front when horizontal, and a good view when going hard. It sits at about 45 deg.