ssd-spacer goes between an SSD and the side of a 3.5" server drive caddy. The advantage of this design is that it does not place a 1 or 2 mm layer of plastic under or next to the SSD. This allows the SATA connector to remain aligned in the bottom right hand corner of the drive bay.

This project is in mostly stable. Prototypes have been printed and tested in the real world. Measurements are very accurate, but some filing of screw holes is necessary.

When using the Lulzbot's recommended profile for Cura, which sets the layer height to 0.25 mm, a Lulzbot Mini printed this object in about an hour.

ssd-spacer is designed with ImplicitCAD.

Parts Needed

You will need one or two metal files, one capable of trimming the bottom edge and a round pointy one to fit inside of small screw holes.

Source Code

git repository