This is a replacement divider for the cup holder in the center console of a 2nd generation (something like 2009 - 2013) Mazda 6.

It is publicly available over at OnShape if you want to modify it in any way.

I sliced off the bottom 0.3mm in Slic3r before I generated the gcode in order to clean up the channels on the sides. OnShape left an artifact right at the bottom when I did the subtraction to create those channels. It was my first time using it, so I couldn't figure out how to fix that. If you can't do that, just take a razor knife and cut it out of there once you print it. It's only going to be 1-2 layers.