Designed this mount to attach a small micro servo motor to.
The case is to hold a PCB with an Arduino Nano and Raspberry Pi PICO mounted.
The circuit that operates it works from an Infrared Signal.

You can check out the YouTube video for the project here: https://youtu.be/YhIa19D6slQ

materials you need:
The parts I used in the test rig were:
1.An Arduino Nano microcontroller
2.A PICO microcontroller

1. 2x Bread boards
2. 5Volt Relay
3. Infrared receiver
4. Servo Motor
5. NPN Transistor
6. 2 LEDs
7. Diode
8. 2x 100 Ohm resistors
9. 1x 15k Ohm resistor
10. 1x 3k Ohm resistor
11. Philips Infrared Remote Control (or any type of infrared transmitting device)
    14 Jumper wires males to male and male to female if your planning on only making
    the breadboard style test circuit
12. USB Cable

Tools:
Side cutters
Soldering Iron
Flux cored Solder
Flux
hot glue gun
Multimeter
X-ACTO blade
5 Volt power source or 9V battery (if using 9V battery only connect to VIN terminal on Arduino)
Electric Drill
Drill bit set