A slimmer version of the Philips Hue dimmer mount. The mount is 50mm wide and have two holes on the back for the magnets. Remove the magnets from the original mount and glue then in place on the new one.

Use double sided tape to mount it on the wall.

i printet it in the orientation that the it is imported to the slicer for higher resolution.

A 65mm version is in on the way to fit next to some of my other switches in the house :)

UPDATE (16-01-2019)
Guide slot moved and made bigger
Fillet on dimmer slot made smaller to make a small edge for thee dimmer to rest on

UPDATE (15-01-2019)
Magnet holes made deeper to get them closer to the controller.
slot for the dimmer adjusted in size