Print with "initial" layer height 0.22mm , then layer height 0.2mm, 8% infill.
Add supports only to the underside of the semi-sphere on the pole, the aim being to have the best surface quality when supports are removed whilst retaining and supporting the delicate cross bar beneath.
The ninja stars can aid you with adhesion and levelling.
The "Inlay" lettering should fit inside the "inlay" rectangle once complete
There should be no sag on the bridges.
there should be no stringing between the two spikes
The overhang test should tell you how far you can print an overhang without support material. Each section gets steeper by 15 degrees until 90 degrees.
The overhang test completes when you can print the tiny sunglasses on the top - cool!
The "Small Text" should be legible and complete.