Hi, guys.

At first I printed this one thing made by 3DBrooklyn. Here it is: http://www.thingiverse.com/thing:173316

But, in my country there's no such size of big BIC-lighter. After finishing printing I saw, that small BIC can't be installed on it's place.

Here's the adapter for small BIC Lighters (73-75 cm tall). The height of case is 95 cm. Print it on the original maker's page 3DBrooklyn: http://www.thingiverse.com/thing:173316.

May be you'll required a bit sanding at the smallest partition (2.5mm) on the top side for better cigarette reject.

Print the model so as it in STL-file. No rotation required.
Good luck, and don't forget — smoking is killing you:)