Had been needing a phone stand that could accommodate a variety of phones as I was printing a batch of about 20 to give as gifts but the ones I was finding all required the use of lots of support material which just wastes material and increases print time. As well as this, the ones I was finding would only accommodate certain phones in certain cases. So, I gave in and just designed one from scratch. The stand I designed uses oval shaped holes so that it does not need support anywhere, as well as being big enough to properly hold larger phones. I designed the area that holds the phone to be bigger so that phones with thicker cases can fit in it properly as well as making the hole big enough so that cases with dust covers for the charging port may fit. The charging wire run through hole is just big enough to accommodate most USB cables but if yours does not fit then just feed it through the opposite charging port side. The STL I am posting has the stand at 80 mm thickness but if you have a thinner phone then just individually scale that size to your preference. The stand also has enough space to allow phones with PopSockets to sit properly.

I attached some picture showing the stand with an iPhone 12 Pro Max Lifeproof NËXT case to showcase how a bigger phone sits properly as well as to show that the charging port dust protector does not affect how the phone sits. I also tested the stand with a Samsung S9 Lifeproof FRĒ case (has a VERY thick bottom portion) and it fit perfectly as well with the charging port open.

All that being said it still does work perfectly for smaller phones and should fit whatever variety of phone and phone case requirements you might have.