Intro

Trial to make a GXP bearing extractor.
This should be printed with a high infill (60%) at least.
DISCLAIMER: Not yet tested !

Parts

To be printed

• 1 GXP bearing extractor

Additionnal

• 26mm washer
• 32mm washer
• 8mm threaded rod
• 2x 8mm nuts

Mount

Use the 32mm washer on the top of the extractor and the 26mm washer for the inside of bearing. Then, "simply" tighten the threaded rod slowly and probably help it a bit by using a hammer to extract bearing :D

Sources

If you want to adjust it, get the files and modify them with OpenSCAD
The latest files are available on my github repository: https://github.com/clementleger/3d_parts
Folder: gxp_extractor