This is a mirror holder for a shower caddy as pictured. Our one deteriorated over time and so this was my first build using a 3D printer. I have included a drain hole at the bottom corner to assist with drying and minimise moisture build up. I printed using a CTC in ABS, 220deg head, 100 deg bed, with raft, 50% infil, .2 layer @ 90mmS. I have included the only support structure required which I found to be the best and easiest to remove and clean. I recommend sanding the ball smooth prior to securing the mirror in and using. A bit of silicone will secure the mirror in just fine.

Measures outside: 110w x 78h x 5.5d and accommodates mirror size: 107w x77h x 2mm thick

Enjoy.