Tired of your NanoVNA flopping around while you test your antenna? I made this little stand to give my NanoVNA some stability as I was testing my antennas. Also having it at an angle helps reduce the glare for me when outside. Be sure to enable support, especially for the back stabilzer rail. *** Note, I found the best printing orientation is as if the NanoVNA was sitting vertical, which saves on support material.
Also, this is made for the NanoVNA to snap in lightly on the LH side and not require to much effort to unsnap it if you want to take it out of the holder. I also would recommend using a USB-C 90 degree adapter for the bottom if you tend to use your VNA with the USB cable attached or for charging with it in the holder. I didn't make the angle of the holder adjustable mainly because I wanted it to be solid and able to better to use a spring clamp attach the strut brace to my ladder when I am using it that way. Any suggestions or enhancements, let me know. I'd love to hear them.