Dummy SKR Mini E3 v2.0 board for use to aid in design of enclosures. Included are all major (size) components (outside dimensions). In e.g. the stock Ender 3 Pro case the board sits on top of 4.2mm "stilts" -- but note that the component pins extend ~2mm beneath the board.

Note: BTT published a highly detailed model of this board. However, their model does not include the PCB screw holes.

Reference: board dimensions published by BTT

CHANGELOG:

6/13/21: Tweaked the position of all screw holes excepting lower-left (closest to origin)

4/7/21: Small size/position adjustments:

• The short wire terminal is now set back from left (X=0) edge of the board
• EXP1 block is wider by .28mm
• Micro-USB port is narrower by .1mm
• Micro SD card reader is narrower by .34mm
• All components across the bottom (Y=0) edge of the board have had their positions adjusted