This is a bracket for making a small table or foot stool.
Prints without supports. Check the picture of the slice for the reason why.
Does require some bridging.
Wood used is 2x2
Screws used are Flat Phillips Wood #10 x 1 in.

Depending on material used you might have to sand/plane the 2x2s to fit in these brackets. I designed them to fit snugly, and to be printed on ABS, which has more expansion than PLA, so they could be be a little loose actually.

I did print the brackets out in ABS, and they worked fine, I just didn’t have enough wood to finish the whole foot stool I had intended to make, but I figured I’d throw them up on thingiverse anyways.

I’m working on a more conservative design(wood wise), an I’ll post that when I have it.