A 3D Printable PC case designed I designed and built myself.

Uploaded here in case anyone wants a challenging project.

Also a video showcase on Youtube: https://www.youtube.com/watch?v=DKSNKyu7UWE

Approx 2.5kg of filament.

Case specifications:
Motherboard size: mITX (170x170mm)
Supported Graphics Card: 280mm Length, 2.5 slot max
PSU size: SFX (Mine is Corsair SF750)
CPU Air Cooler: Low profile air cooler ~60mm height max
Distro Plate: Rear Panels Designed for Lian Li PC-O11 Distro-Plate G1 Distro Plate
Cooling Front: 2x 120mm Fans with 240mm Radiator
Cooling Bottom: 2x 120mm Fans with 240mm Radiator
Overall Size in mm (Including Pump, Feet & Side Panels): 520W x 460H x 240mm

Note: I have only built this as a water cooled setup. Results may vary with air cooled setups.

Use files at your own risk, I take no responsibility for property damage / injuries etc.