Magsafe adapter (https://www.amazon.com/dp/B0DLP157QH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) for a desk command center/panel system. This one has one side cut out to accept 5x3 mm magnets but they will only fit in with a solder pushing them in which helps to secure them. 

Hexagon cut outs on the side to run wires through them. Inside there is a cutout to accept a 90 degree usb c adapter (https://www.amazon.com/dp/B0B77CJD7T?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1). 

I used:

• Gyroid infill pattern with 20% infill 
• 6 wall loops
• 6 top shell (optional Octagram top pattern as I like the way it looks)
• 6 bottom shells
• 6 mm brim (as I printed in PETG in a really cold garage in the winter)
• 0.24 mm layer height
• really slow speeds for high quality finish
  • 20 mm/s initial layer
  • 25 mm/s initial layer infill
  • 40 mm/s outer wall
  • 60 mm/s inner wall
  • 60 mm/s sparse infill
  • 50 mm/s internal solid infill
  • 120 mm/s travel speed
  • 50 mm/s bridge
  • 230 mm/s gap infill
  • 70 mm/s support
  • 40 mm/s support interface