I needed a simple stand for my lightsabers, and designed this one from scratch. It fits handles up to 65mm in diameter and raises the lightsaber approximately 7cm. 

I chose to print 2 at a time very fast, with a 0.3mm layer height and 20% infill. It took around 75 minutes. Better surface quality can be obtained by going down to 0.15mm layer height. Or use variable layer height and go as low as 0.1mm for the sloping top part.

My lightsaber is equipped with a fullsize 40 inches blade, and it's held very secure. 

No supports needed.

No brim/raft needed.