A finely detailed horned owl (Strix) perched on a branch, sized as a charm for earrings or necklaces — about 25 mm tall, with a jump-ring bail baked into the crown so it hangs facing forward.

🦉 At a glance

• About 12 × 11 × 25 mm
• A jump-ring bail is baked into the crown so it hangs facing forward
• Add a 6 mm jump ring plus a fish-hook ear wire for an earring, or a lobster clasp on a short chain for a pendant

🧵 A note on material (see the photo)

💡 The pictured pair was printed in wood-fill PLA, which is NOT recommended for a piece this small and detailed. The wood particles cause stringing and fuzz and blur the fine feather detail. For a clean result print in plain PLA or silk PLA — a dark or metallic silk especially flatters the owl. If you do use wood-fill: dry the filament, drop the nozzle temp ~10 °C, raise retraction, and slow down.

🖨️ Print settings

Setting	Value
Printer	Bambu Lab (any FDM)
Material	PLA or silk PLA (wood-fill not recommended at this scale)
Layer height	0.12–0.16 mm (fine, for crisp feather detail)
Walls	3
Infill	20 %
Supports	Recommended (tree) — chin, brow tufts and talons overhang
Orientation	Standing, as exported

💡 A brim helps the small footprint stick to the bed.