Exhaust pipe baffle. It can be used to connect pipes to the exterior wall. I use it to connect the exhaust pipe of the P1S to the outside. The hexagonal mesh prevents insects from entering. It includes screw holes, allowing it to be secured with screws or straps.

The included print configuration is suitable for 100mm (4-inch) pipes with a 120mm baffle, but you can adjust the parameters as needed.

To enable printing with a 0.4mm nozzle and a layer height of 0.16mm, the size of the hex hole must be at least 4mm. If mounting holes are not required, set `mounting_hole_diameter` to 0.