This is for a laser that has a 10mm focal distance or more

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

I designed this piece to hold a magnet I got from amazon for making a different print and had extras left over. It's a strong magnet and has a really good grip on the honeycomb bed of my laser.

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

You will need to order these magnets from amazon, or one with the same dimensions in order to fit the hollow space I put in the middle of of the bottom attachment: Cup Magnets, 95lbs Holding Force 1.26 inch D x 0.2 inch H, 12pcs Super Power Round Base Magnets Neodymium Rare Earth Magnets with Countersunk Hole, Screws for Home Workplace, Kitchen

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

The third piece is a support for the center of the material being held. It is the same height as the magnetized base.