This bracket relocates the cfs Buffer for the D3P K2 Plus riser ensuring smooth operation and clean up the tubing and cabling on the back of your setup.  The bracket snap right into the back of the D3P K2 Plus.  Its a quick print and you can reuse the 3m screws to secure the buffer to the buffer mount, then snap it into the D3P K2 PLUS riser.

 Assembly Instructions Simply disconnect your wires and tubing from your buffer, then unscrew your current buffer.  Screw the buffer to the buffer mount using orginal screw and then snap into the center two holes of your D3P.  Reconnect wires and tubing.  If your using two CFS you might have to cut the tubing to fit.  Also you can reuse the 45mm cable to one of your CFS 

ONLY TESTED AND PRINTED FOR THE K2 PLUS, It will not fit other D3P Risers.  Check out the D3P riser page for CFS buffer brackets for your riser