PLEASE READ BEFORE PRINTING

This is a simple wired earphone / necklace and all purpose hanger in general! Great for wired earphone users who like to have their wired earphones in one place, and have a place for them to hang it, like me!

This is still the very first version, so a LOT of things to work on, so please read the cautions before printing! If you have any suggestions or want to remix the project, feel free to comment! :)

CAUTIONS

• Before printing: Make sure to set travel speed relatively low (I put mine at 100mm/s) so that the supports print correctly. Ensure to enable supports as well
• During printing: Keep an eye on the supports to ensure they print properly
  After printing: The supports may be a bit hard to remove, but using a pair of scissors to remove it worked for me. Take care to ensure you dont use too much force so as to not snap it.
• While using: Please take great care with the hinge, it is easily the most fragile part.

PRINTER SETTINGS

• Printer: Bambu Lab X1C, Textured PEI plate, 0.4 nozzle, PETG (gray) filament
• Settings: Enable support (tree auto, default 30 deg), slow down travel speed to 100mm/s and travel acceleration to 1000mm/s^2

CREDITS

Made in blender and printed all by me. No external assets used.

Commercial is OK, remixing is OK and selling it is OK! make sure not to break it though