This 3D-printable frame was designed to convert a PULSAR socket unit originally intended for a two-socket installation into a clean single-socket setup.

The original surrounding frame is made of glass and cannot be cut or separated without breaking it. This printed replacement provides a simple solution: it is pushed directly onto the socket assembly and stays securely in place through its friction-fit design. No screws or glue are required.

Important Installation Note

The inner metal mounting frame supplied with the product is also designed for two adjacent sockets. To use it as two separate single-socket units, the metal frame must be carefully cut through the center.

Cut edges may be sharp and should be properly deburred before installation. Always disconnect the power supply before working on the socket. Cutting the mounting frame and performing the electrical installation should only be done by a qualified person in accordance with local electrical regulations.

Compatible Product

Designed for the PULSAR GaN PD 65W socket available here:

https://amzn.eu/d/0ccbuzTZ

Please compare the dimensions and shape of your socket with the model before printing, as the manufacturer may change the product design over time.