Summary

This is a little gundam robot that I designed. It's definitely more of a toy than any kind of real gundam figure. Technically it is articulated, but its range of motion is limited - and as is the case with 3d printed joints, it doesnt hold any particular pose. I think its pretty fun though.

I designed it in a way where no supports will be needed to print it. Simply load the pre-plated STL and print. I printed at 0.18mm layers, with retraction and coasting enabled.

Some of the joints are print in place, so want to eliminate stringing as much as possible as this may cause them to fuse together. Don't be alarmed if they seem stuck when you first take them off the build plate though, This is normal. A bit of gentle persuasion will loosen them up.

Some of the pegs are a bit loose, and others might be a bit tight. I used super glue to hold the pegs in place.