Boeing 737 Display Model ✈️

Hey everyone! Here’s my 3D model of the iconic Boeing 737, split up to make printing super smooth and easy on supports.

🧩 Assembly

To get a clean finish, the plane is split into 5 simple parts:

• 3 fuselage pieces (nose, middle, and tail)
• 2 wings (left and right)

You’ll need a bit of super glue (CA glue) or plastic cement. Just glue the three body parts together, slide and glue the wings into their slots, and hold them for a minute until it sets. Easy!

📏 Scaling the model

Feel free to resize it to fit your printer!

• Bigger: Works amazingly well. Scaling it up gives you super clean details and an even easier assembly.
• Smaller: You can scale it down to about 70–80%. Just be careful with the trailing edges of the wings – if you go small, try a 0.2mm nozzle or lower your layer height (0.12mm).
• Pro tip: Just make sure to scale all parts at the same percentage so everything fits together tightly.