First step is to remove the bottom rubber feet of your audio interface and reattach them to the stand itself.

Second step is to gently push the interface inside so it is flush with the front face of the print.

Then attach all the cables.

Slowly I will be adding more of the UA VOLT stands, but for now, I will leave this one online and hope, that people will find it useful. I have made a hole in mine for a ¼ jack splitter, but uploaded one without it.

For best quality print and to not use too much filament for this, print it on its face with 10% gyroid infill.

If you have any questions about other universal audio interfaces, please send me a message. I will design them for you, but cannot test them.