Hi I designed a Pain lid holder/stand. I hated having to get my fingers painted while handling the lid. The other pet peeve of mine was not being able to set it somewhere,  knowing that I would regret picking it back up.

It uses 3 round rare earth magnets 5mm x 10mm. I added a pause during the print to add these in. These are magnets that I had lying around. I think any 5mm x 10mm should do the trick.

I would like to continue to improve upon this design. I think the cylinder is a little too wide for fingers. I think I can also improve on the amount of filament, I'll continue to improve in those areas as I continue to learn more.