Description

With this holder, collect the models and fill your wall with them!

It can be fixed on your wall by push pins or small nails.
If you use low-profile push pins, you can store a description card in the back-side pocket together with the model.

You can pull the model forward (toward you) to remove it, so, even if the holders are placed close together vertically, they won’t interfere with each other.

Design File

To enable your customization, I share its STEP file.

Printing

• Any filament
• I used 0.28mm layer height draft mode

My Educational Mechanical Examples Series

This model is for my educational mechanical mechanism examples on 80mm x 80mm base plates.
You can find all models in the series in this collection => [Mechanical Mechanism Examples]

License (2026-03-13 updated)

• The 3D model(s) are licensed under Creative Commons Attribution 4.0 International. (unchanged)
• However, the text and images on this page are copyright reserved. (added on 2026-03-13)