Hello,

This piece is simple, but for my hobby "woodworking", I needed to make a carriage for my sawing table "Evolution Rage 5". So even if it's nothing too fancy, why not share this room?!?!

This carriage is a wooden plank that slides parallel to the saw blade and opens up a multitude of cutting possibilities.

The objective of the project is to manufacture the parts that will be fixed under the board that will slide in the rails.

In my project, I use 2 pieces per rail in order to have a sufficient length. The rounded corners make it possible to place 2 pieces one behind the other.

If you would like more information, I am available to answer you.

Technical description:

• Length: 450 mm

• Width: 19.6 mm

• Height: 6.5 mm

• I print in 0.2mm

• Printing time: approx. 1.5 hours