Turn an inexpensive plug-in night light into a glowing crystal accent light! The crystal is designed for Spiral Vase mode and works especially well with translucent or transparent filament, while the snap-together base requires no glue and can be easily disassembled if needed. There are three crystal sizes, so choose what works best for you: Short, Medium, or Tall.

You can pick up a four-pack of the same night light I used from Amazon with this affiliate link.https://amzn.to/4vWRG6p

Assembly is super easy:

1. Remove original diffuser from night light.

2. Slide on base, secure with C-clip.

3. Slide on crystal. Done!

I had fun designing this, and I hope you have fun printing and using it!

For the Base and C-Clip, use standard settings with a 0.2mm layer height.

For the Crystals, use Spiral Vase Mode with 0.2mm layer height, 0.8mm outer walls (works fine with a 0.4mm nozzle), and 20 solid bottom layers. See video for details.