I added a way to clip the holder right below the Led strip so that the Hygro/Therm is directly facing the door. I also stretched the length and opened it up so that its not in the doors blind/reflective spot but should be able to be visible from the Led lights. You are able to move it from left to right placing it where you feel maximizes its potential. Plus if you don't want to place it in the adjusting position (Circle) you should be able to place it right on top facing upwards. Let me know what you think. I'm also working on a modified rear side mounted spool holder that hopefully maximizes proper height and pull while minimizing drag and tension. Sorry I didn't take any pics for this as it was my 3rd modification . hopefully its the final rendering. I also added the cuts I used in case someone wants to mess with it. Update... As you can see it works. But I did have to force the unit into the holder rings as it was a bit snug so if you widen it just a little bit (1 - 3cm) give or take then you are good to go... I am almost done with my rear side arm spool holder. I'll post it once completed and possibly printed so you have the actual item to see vs a AI generated Pic.