Summary

Proto-Full Base

Base can be mounted as it has two chamfered M3 holes, and four #8 screw holes.

To install the brass inserts:

Place nut over tip of soldering iron (pointy tip). Let heat up for just a few seconds.
Make sure the up side, is down on the iron, or the nut will be installed upside down.
Gently press the nut into the 3D printed standoff. Don't push all the way, stop when the nut is about 1mm out.
Use a small piece of PCB or something else flat and firm to press the nut in the rest of the way.
Reheat with iron if it cooled too much. Go slow and low heat.

Find product documentation and supporting material on our Documentation Subdomain: docs.PTSolns.com

RESOURCES

Datasheets & supporting material on PTSolns Documentation Repository:
https://docs.ptsolns.com