I have a Craftsman screwdriver that uses ¼” hex bits. But there is no storage for any extra bits, so I made this little hex bit holder. Not to use all the time but it can be handy to have once in a while.

The shank on this screwdriver measures 9.7mm’s diameter by 77mm’s long.

This is a little sleeve that slides over the shank of the screwdriver and it holds (2) ¼” hex bits.

I bought some tiny magnets, 6mm’s X 2mm’s and I super glued one in the bottom of each hex pocket.

A basic and simple design and a fast and easy print.

Printed in ABS so I can use super glue