This is a light box based on the design of the Beatles' logo. It would be a perfect addition to any Beatles collection. Any fan of the Beatles would love it.

I've already added holes to the backplate. If you don't need them, you can just delete them.

Also, please rememberWhen creating the front side, please select "Standard light box front" from the drop-down menu. When creating the back side, please change it to "Standard light box back" from the drop-down menu.

Bambu Studio

Just follow my configuration, and everything will go well. Of course, feel free to make changes according to your preferences. Here are my settings:

Printing plate type- Textured PEI printing board

Quality- Elephant Foot Compensation - 0

Quality- Arachne - Default settings

Intensity- Number of bottom shell layers - 5

Intensity- Internal entity filling mode - monotonous

Intensity- Sparse filling density - 5%

Intensity- Sparse filling pattern - Gyroid

Speed- Initial layer - 25mm/s

Speed- Initial layer filling - 50 mm/s

Other- Skirt hem type - No skirt hem

Other- Skirt hem width - 1

Assemble the light box

I tend to use aluminum foil tape to make the backplate, which can better reflect the light. I use strong glue and activator spray, but I'll be very careful to control the amount of glue. If there's too much, it will drip to the edge and leave white marks after drying. I usually use these lamps5V USB LED strip SMD 2835, 50CM, 1M, 2M, 4M, 5M, white/warm white/red/blue/green, IP21, flexible lighting strip for backlighting - AliExpress 39When placing the LED strips in the light box I made, please try to keep them in the middle of the wall. If they are too far back, it will be difficult to attach the back panel. If they are too far forward, the lighting effect won't be as good.

If you have any questions, please leave a message for me.