This honer accepts a relatively common diamond stone and presents a one degree angle to the ski base. The original part has a base angle of 2 degrees despite advertising 1 degree and this remix corrects that. It has dimensions suitable for the red/blue/yellow diamond stone set (2.6 cm x 7.7 cm of active diamond surface) sold on ebay. It is simple to modify for a different size of stone in Blender. The base angle can be calculated from the grid in Blender as inverse tan (1/57), which is 1.005 degrees to 3 decimal places. With a perfect print, the diamond stone should protrude only 0.2 mm below the corner with the side edge, minimising the likelihood of remove base structure as well as metal. Use with discretion and avoid taking off more metal than intended! Unlike side edge honers, base angle honers should be used only if there is an obvious irregularity in the narrow base edge face, as frequent base edge honing will reduce the time before a full commercial base grind is required, to align the base structure geometry with the metal base edge again. Skis that have over-honed base edges are unreactive and skate rather than carve. Edges can be tested for sharpness by scraping a finger nail sideways across them and should produce a fine white dust.

Doesn't Matter

0.2 mm

25%-100%

ABS