Wanted some junction boxes to extend the length of my low voltage led accent lights.

Printed in 100% infill polycarbonate on Qidi Plus 4 with generic Polycarbonate setting in enclosure.

Drilled out the 4 closure holes on the backside a bit and bonded in threaded #6 inserts to close it, although the tolerance for the lid is very tight. (Screws not installed in picture, but they work)

Customized version of https://www.thingiverse.com/thing:4666908

Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=4666908

Using the following options:

cutout_1_Radius = 4.8
cutout_1_Z_Adjust = 3.6
cutout_1_X_Adjust = 6.6
cutout_2_Radius = 4.8
cutout_2_Z_Adjust = 3.6
cutout_2_X_Adjust = 6.7
box_Size_X = 60
box_Size_Y = 35
box_Inner_Height = 18
box_BottomTop_Thickness = 2.8
box_Screw_Corner_Radius = 10
box_Screw_Diameter = 4
box_Wall_Thickness = 3.2
barrier_Thickness = 3
barrier_Height = 4
barrier_Tolerance = 0.1
screwnose_Number = 0
screwnose_reversed_Number = 2
screwnose_Diameter = 6
screwnose_Height = 5
screwnose_Wall_Thickness = 6