I bought a Anycubic MEGA S without electronics and need to adapt a full graphics smart display controller to the front. The display mount is taken form another display tweak for a 3.5" TFT display wich you can find here: https://www.thingiverse.com/thing:4728282 (by Kristoffer Pufel - Kris_3D_Druck).

The ANYCUBIC front sticker reduces the mounting hole for the display. You need to cut out the sticker to the maximun possible space.

Unfortunally you need to raise the height of the printer feets 2-3 mm. The sd-card is not easy to remove for poepble with huge fingers. Use this Card-Extender for an easyier access to the SD-Card: https://www.thingiverse.com/thing:1335637 (by Chris Midgley)

Printed layer height 0.2 with supports.