Insert for "Muffin Time"

This insert has been designed to make the most of the available space in the box of the board game "Muffin Time". It consists of 3 main elements, each with a specific function.

Print Settings

• Layer Height : 0.2 - 0.3 mm
• Material : PLA
• Supports : No
• Infill : 5%

Box_card

• Description: This box is dedicated to storing the game cards.
• Dimensions: 66 x 120 mm.

Attention!

The game cards have been protected with protective sleeves, which slightly increase their size:

• Width: Increases from 64 mm to 66 mm.
• Total height of the card stack: Reaches 120 mm.

⚠️ IMPORTANT NOTE ⚠️:
The dimensions of the Box_card (66x120 mm) were specifically chosen to accommodate cards with protective sleeves.

• If your cards do not have protective sleeves, you may not have issues with width, but the stack of cards might be too short and could fall inside the box.

📢 Request: If anyone knows the exact dimensions of the card stack without protective sleeves, please leave a comment! I would be happy to design a new version of the Box_card with more suitable dimensions.

Box

• Description: An empty box useful for storing:
  • The game rules.
  • Any extra cards or other components.

Base

• Description: A small fixed riser that is placed at the bottom of the box. It serves to:
  • Increase internal height.
  • Keep the cards at the right height for easier access.

General Feature

All the components of the insert are separate from each other, making it more practical and flexible to use.

Support me

If you found this project helpful and would like to support me, you can do so via PayPal by clicking this link: paypal.me/Jvita307 . 🙏

Every contribution is greatly appreciated and helps me continue creating useful content and resources for the community! Thank you so much for your support! ❤️